Flywheel housing and clutch cover coil spring and diaphragm clutch
diameter bearing idler gear: 1.004" (25.5 mm)
3-synchromesh gearbox
Required: 1
diameter bearing idler gear: 1.065" (27.05 mm)
4 synchromesh gearbox
Required: 1
in flywheel housing for 1st motion shaft
outer ring fitted in housing, bearing fitted on shaft
Required: 1
for outer ring bearing 200516 in flywheel housing
Required: 1
for inner ring bearing 200516 to shaft
Required: 1
for idler gear, outer diameter bearing: 1.004" (25.5 mm)
3-synchromesh gearbox
Required: 1
for idler gear, outer diameter bearing: 1.065" (27.05 mm)
4 synchromesh gearbox
Required: 1
flywheel housing to engine and gearbox
Required: 1
for fitting flywheel housing
Required: 7
in flywheelhousing
Required: 1
in flywheelhousing
Required: 1
in flywheel housing
Required: 1
clutch and flywheel housing
A series gearbox
with time mark hole, alternative cover 306984 could be used
Required: 1
clutch and flywheel housing
A-plus series gearbox
no time mark hole, alternative for 306631
Required: 1
for timing mark hole
only for clutch cover 306631
Required: 1
fitting cover time mark
only for clutch cover 306631
Required: 2
fitting cover time mark
only for clutch cover 306631
Required: 2
to hold release bearing on the shaft if the bearing is mounted floatingly
Required: 1
press fit of release bearing
Required: 1
if release bearing fits loose on shaft
Required: 1
end stop for clutch operating plunger
Required: 1
for return spring on clutch slave cylinder
Required: 1
for clutch and clutchhousing, 14 parts
Required: 1
